Introduction: Model Robot With Storage Space

This model is based happening the Instructables robot. It can constitute gain display, only with a handy storage space at the front!

Step 1: What You Want

Cardboard

Swayer

Sword

Scissor

Pencil/Compose

Masking Tape

Sticky Tape

Straws

Paper Fastener

Step 2: The Head

First of all, make a net of a cube. I successful each squarely inside 5 cm x 5 cm. So I have a 5 x 5 x 5 cube. Then, score from each one fold with the blade so later you can easily fold it. Subsequently this thin it out. You whitethorn want to commit a deeper grievance around the outside of the net to make information technology easier to cut.

Step 3: Collection the Square block

Fold the clear so that the scores and the lines are on the inside. Then, exploitation sticky tape, assemble the regular hexahedron. Make reliable information technology is sealed securely. Hold up on using sticky tape until you get unmatchable flap left. It will represent impossible to seal this downbound unless you use tape on the alfresco, so use the masking paper. This will hateful you fundament paint it later on.

Formerly this is through, proceed to covering the gross cube with masking paper.

Step 4: The Body

Now brand 4 rectangles. The first two should follow 14 cm x 9 centimetre. The 3rd should be 14 cm x 7 Cm. The final extraordinary should be 14 atomic number 96 x 5 cm. Straight off, lay them all position by root, longest to shortest. Attach them together with awkward tape and masking tape recording. Now make up a 14 cm x 14 curium lame and attach that to either end of the cardboard train that you made. Attach the end of the square now to the other stop of the artificial train. It should search like a 3d pentagon that you fire look through.

Mistreat 5: The Body

Now, lay the pentagon thing on it's side and trace prohibited the area where information technology's empty. It volition look like an irregular pentagon. Cut it tabu and attach it to to a side of the 3d pentagon. Repetition for the other side.

Step 6: Attaching the Head to the Body

Now, using masking paper, joystick the head on to the body. Then, cut back stunned 2 equal sizes of straw (depending on how long you want the antennae to be), and put four slits in it and open it rising. Cut out a lot from the composition board and using screenin tape, attach it to the heart. Now make some other antennae and attach it to either side of the head.

Step 7: Arms

Victimisation some paper card, switch off knocked out two 14 centimetre x 9 curium rectangles, and roll them up to make two tubes. Put forward the tube together with two pieces of wet tape. Now, pinch the pinch of the tubing and seal information technology similar that with some more sticky tape. Spend a penny a tiny slit at bottom the pinched in concert area of the two tubes and push a paper fastener in. Now make a small slit in the sides of the body where the arms would go. Push the wallpaper fasteners with the arms into them. You're now almost done!

Stair 8: Finally...

Finally, turn the robot around to it's front and prick open the sticky tape recording attaching the scarred panel. Open the flap up and it's ready for use...unless you want to add foster decoration!

Step 9: Thanks

Thanks for reading this instructable. If you need Sir Thomas More photos, steps surgery description, post a remark along what on the button you need. Post a impression of your creation in the comments! And delight follow, ilk and partake in!

Cheerio!

super_me

Be the First to Share

Recommendations

  • Anything Goes Repugn 2022

    Anything Goes Contest 2022